(02-17-2015, 12:00 AM)admin Wrote:

(02-16-2015, 10:12 AM)zaphire Wrote: I used the VHD option of WinToUSB_Setup_2.0_VHD.exe to successfully write a VHD to a 64GB Corsair USB 3.0 key but it was woefully slow both to write the files and to complete the installation of drivers and Windows etc.
The Windows 10 ran woefully slow from this key too.
I would definitely suggest only using a USB 3.0 connected SSD in future.
I decided to try copying the VHD file from the USB Key to an internal disk (a SSD) in my notebook and boot that way.
It then ran fast and was quite usable.

I then tried the 3rd option of selecting an operating system from a Hard Drive but when this is selected the option to create a VHD is greyed out! Legacy is the only option and after rebooting nothing is written to the external SSD!
But a WinToUSB window pops up saying Cloning, please wait...
And on top of this an Error window saying: Specified disk not found.(0X0005003501220000)

---

I have since tried the latest build 2.1 beta (Build: Feb 12 2015) and upon starting the program I get an error window [error 1] attached then a further [error 2] attached.

Question 1: The common flash drives are always slow, so we highly recommend using a Windows To Go Certified Drives or USB hard drive. If you don't have enough budget to buy a Windows To Go certified drive, We recommend to you to buy a SanDisk Extreme CZ80 USB 3.0 Flash Drive, it is fast enough to run Windows smoothly and more cheaper.

Question 2: The VHD mode is not supported when Clone current Windows OS to a USB drive. When pops up the 0X0005003501220000 error, please follow these steps:
Step 1. Open a command prompt ("Tools" > "Windows command prompt")
Step 2. Execute the following command to listing all recognised drive
>diskpart
>list disk
Is the source and target disk list here?

Question 3: I have fixed the problem, please download http://www.easyuefi.com/wintousb/downloads/WinToUSB_Setup_2.1_Beta.exe and try again.

(02-17-2015, 10:48 PM)admin Wrote: Try this patch: http://www.easyuefi.com/wintousb/downloads/WinToUSB_Setup_2.1_Beta_Patch.exe
________________________________________________________
Question 2: The VHD mode is not supported when Clone current Windows OS to a USB drive. When pops up the 0X0005003501220000 error, please follow these steps:
Step 1. Open a command prompt ("Tools" > "Windows command prompt")
Step 2. Execute the following command to listing all recognised drive
>diskpart
>list disk
Is the source and target disk list here?

(02-20-2015, 11:04 AM)admin Wrote: Make sure to use the VHD install mode when installing to a USB flash driver.

(02-20-2015, 11:41 AM)tfcb Wrote:

(02-20-2015, 11:04 AM)admin Wrote: Make sure to use the VHD install mode when installing to a USB flash driver.

Unfortunately even after recreating using the VHD install mode I continue to receive the error message that the boot device is inaccessible.

(02-18-2015, 08:54 AM)zaphire Wrote: Reply to Question 2:
I managed to get a command prompt up but the same error window also popped up!
I executed
>diskpart
>list disk
But only the two internal (1 TB) drives of my notebook showed up!
Disk 0 Online 931 GB 0 B
Disk 1 Online 931 GB 0 B

The external USB 3.0 connected SSD did not show up!