+- Hasleo Software Forums (https://www.easyuefi.com/forums)
+-- Forum: Hasleo Software (formerly called EasyUEFI Development Team) (https://www.easyuefi.com/forums/forumdisplay.php?fid=1)
+--- Forum: EasyUEFI (https://www.easyuefi.com/forums/forumdisplay.php?fid=3)
+--- Thread: Using EasyUEFI to add an entry? (/showthread.php?tid=1999)
Using EasyUEFI to add an entry? - janellefabre - 05-30-2024
Hello,
I installed Clear Linux on a ThinkPad T495 with a single nvme drive which already had a windows 10 installation. It did not create an entry in the UEFI/BIOS so I used EasyUEFI to add an entry, and could dual boot without grub. geometry dash scratch now I've installed Clear Linux on a new SSD and then installed Manjaro, which shrunk the Clear drive partition and created a new EFI partition and installed manjaro on it, but I can't boot into it.
Is there anyone using EasyUEFI to add an entry? Do you have the same issue?
RE: Using EasyUEFI to add an entry? - admin - 05-30-2024
EasyUEFI is a Windows software, so it only works in Windows operating system, does this computer have Windows installed? If not, you can only create a bootable Windows PE emergency disk on another PC, boot and run EasyUEFI from the emergency disk to add boot entry for Linux.