(Please note I've tried the below process using both WinToUSB 2.0 and 2.1 beta versions)
Hi there,
I'm trying to clone a Win 7 SP1 Enterprise, onto an external HDD.
Host drive is Disk 0
Destination drive Disk 1
(for details, please see the screenshot below)
And what ever I try (Diskpart: create only 1 partition, or trying to recreate the both System and Boot partitions as identical as the host drive, etc...) after WinToUSB reboots the computer to start the cloning, I then always have the exact same message each time :
Specified disk not found. (0x0005003501220000)
So I'm wondering : what am I doing wrong?
Knowing the process works on another computer, for a Win 7.1 Enterprise N, but which is using a 80GB HDD, and knowing I didn't had to create the both System & Boot partitions. I indeed, only had to format the external drive properly, using Diskpart.
Hoping you could help, I thank you in advance for your replies.
Kind Regards,
David
PS.: Please find attached the user.log file in case you would need it.
user.zip (Size: 2.05 KB / Downloads: 3)
Hi there,
I'm trying to clone a Win 7 SP1 Enterprise, onto an external HDD.
Host drive is Disk 0
Destination drive Disk 1
(for details, please see the screenshot below)
And what ever I try (Diskpart: create only 1 partition, or trying to recreate the both System and Boot partitions as identical as the host drive, etc...) after WinToUSB reboots the computer to start the cloning, I then always have the exact same message each time :
Specified disk not found. (0x0005003501220000)
So I'm wondering : what am I doing wrong?
Knowing the process works on another computer, for a Win 7.1 Enterprise N, but which is using a 80GB HDD, and knowing I didn't had to create the both System & Boot partitions. I indeed, only had to format the external drive properly, using Diskpart.
Hoping you could help, I thank you in advance for your replies.
Kind Regards,
David
PS.: Please find attached the user.log file in case you would need it.
user.zip (Size: 2.05 KB / Downloads: 3)