Unable to create WinPE.iso

[neversaynever1]

63% is what I see displayed on the progress bar. Before reaching 63% I seem to remember that the values displayed are: 5%, after one second 25%, after 15 seconds 45%, after another 20 seconds 62%, and after an instant 63%. And there it stops.
On my second PC, if I remember correctly, after 62% it waits about ten seconds to go to 72%, then quickly to 100% and finish.

Please try the version below to see if you can create WinPE properly.
https://www.easyuefi.com/backup-software...231213.exe

Wanderful. I installed the new version . The bar moved to 5%, 15%, 20%, 45%, 63% in less than a minute. Then it remained at 63% for about 2-3 minutes (in the meantime the Backup Suite Worker process was occupying the CPU at about 20-25% and no Hasleo process appeared "suspended"). After 2 minutes the bar jumped to 99% and soon after to 100% ending the operation.
The process took longer than on my 2nd (and slower) PC, but everything is now OK and the WinPE.iso file (which I saved so that I could later create with Rufus a USB disk), is also correctly located in the Hasleo 'bin' folder.
Thank you for your promptness and seriousness in dealing with this rare problem. For my "education" (even though I am 75 years old it is never too late) I would be curious to know broadly what was blocking the creation of WinPE and the suspension of Hasleo processes.
Thank you again for your patience and spirit of service.